Bsp2Wad.exe by Geoff Phillips (c) 1997 Version 2 (bug for Erased texture fixed) This program, written in assembler, lifts all the textures out of a BSP file as used in Quake, and creates a texture file (.WAD) ready for use in Worldcraft or some other editor. To run, simply type BSP2WAD file.bsp and instantly (because it's a fast piece of assembler code, and not any of this high-level "%&!^) you have your wad file. You can also specify an output filename, so BSP2WAD file.bsp blob.wad. --------------------------------------------------------------------------- ;tamper protection: the isitsame value for this exe is "Managers shake baldly with a book", if you want isitsame.exe to check this, go to my page Rights reserved. This program may be freely distributed, but not may sold or released with other packages without my prior consent. Worldcraft is a trademark of Ben Morris, and Quake is a trademark of ID software. Contact binky@DeathsDoor.com or write to 9 The Don, Bletchley Milton Keynes MK3 7PX England. If Bletchley sounds a dull place, just remember it was here that Colossus was built during World War 2, Turing, Enigma blah blah. Disclaimer: If this program causes you any injury or loss, tough. Use at your risk, though it's hard to see what on earth this program could do with simple file handling.